- #Bush removal from washing machine drum how to
- #Bush removal from washing machine drum full
- #Bush removal from washing machine drum professional
On Zanussi, AEG, Tricity Bendix, Bosch, Siemens, John Lewis and Electrolux machines (they’re all pretty much the same regardless of what the marketing literature tells you) the cabinet splits and the back has to come off or front to extract the entire tub. The seal really has to be replaced as well.
#Bush removal from washing machine drum full
This is probably one of the easiest to do and means that you have full access to the insides of the outer tank, so you can check for other problems. Some others, like Servis and Antonio Merloni based machines, have a bearing plate that is released by a clamp band at the back and the whole back of the tub comes off, heater included. I know that sounds easy, but trust us, on some it isn’t just as simple as it sounds. Older machines that were well built were pretty straightforward assuming that there was no damage to the drum shaft as they had a “spider and shaft” on the back which you simply removed a few bolts to draw off, change the bearings and put it back on.
#Bush removal from washing machine drum how to
The first thing you have to work out is how to get access to the washing machine bearings and seal.ĭepending on the type of machine this can be relatively easy or just an absolute pain. Most common bearing, drum and drum seals are available from the different suppliers around this page do shop around as there can be a great difference in prices You also do not want to miss a part that you should replace whilst at it, like a tub seal for example and this is where a little expert guidance can come in handy. When accessing the washing machine, make sure you disconnect from the electric supply!Īlso ensure that you have ALL the spare parts that you are likely to need to hand as the last thing you want is to stop half way through the job. Not all models on the above machine have sealed tanks so check with the part supplier first before starting the job. The reason, they say, is to cut down production costs. To make it even worse some manufacturers, notably Hotpoint, Ariston, Indesit, Electrolux, Zanussi, AEG and Tricity Bendix have introduced sealed tanks where bearings cannot be replaced, you have to replace the entire inner working of the machine. That bearing now slowly rusts over time and, eventually will collapse due to the oil or grease being washed out and will start to get noisy on spin What will usually happen is that the water seal on the front bearing (which often relies on a brass bush on the drum shaft to seal against) will fail and allow water to pass into the front bearing.
These images below shows a typical bearing set for a washing machine or washer dryer. In the main there are two bearings in a washing machine and a seal to stop the water leaking through to the bearings.
This is a job that will take up most of your day
#Bush removal from washing machine drum professional
The first thing you have to realise about a bearing change on any washing machine is that, if you’re not confident in your ability to totally strip the machine and re-build it safely then call in a friend who has knowledge of mechanical things like cars or you will have to call in a professional repair engineer. Of all repairs on washing machine this can be one of the most difficult to successfully complete as this requires a complete strip down of the machine.
0 kommentar(er)
